Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Readout flickers with motor running (glass scales)
I have never seen this happen with glass scales. I don't even know what the mechanism would be that can cause this behavior. I.e. based on how the glass scales are implemented, there should be no way for the encoder to do this. If this is line noise, it would be at most one encoder tick going up and down (1 micron is approximately 0.00004") so 1-4 tenths is up to 10 microns. Does the DRO drift over time, or is it just going up and down?
What type of TouchDRO adapter are you using?
Can you post a picture of your wiring and the scale?

Messages In This Thread
RE: Readout flickers with motor running (glass scales) - by Yuriy - 07-27-2021, 12:24 AM

Forum Jump:

Users browsing this thread: 1 Guest(s)