Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
pinout on touchdro board
#1
Hi what is the pin out on the x,y,z axis on touch dro board. I know the 5 volts what are the rest.  I have 5 pins on scale 5 v, a, b, r1 and a ground black
Reply
#2
There is a pinout diagram and detailed description on the page where you purchased the board.
You don't need r1 (that is "reference" and TouchDRO doesn't need it).
Regards
Yuriy
Reply
#3
Thanks found it after going through all the pages. By the way when will TouchDro glass scales V2 board be in? Thanks again Lynn
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)