Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
X axis not working correctly
#25
Hi,
Sorry, didn't see your first message. This thread was 2 years old, so I wasn't paying attention.
What version of the board do you have? The original DIY kit used different firmware from the current kit. The new kit uses that same firmware as the pre-made boards, and I sold hundreds of those, so the firmware is very likely not a problem.
It could either be an issue with soldering (which you seem to have ruled out), or defective/damaged MSP430.
Anyway, it would be helpful to know what you built and possible see a picture of the finished board.
Thank you
Yuriy
Reply


Messages In This Thread
X axis not working correctly - by edeeec - 01-03-2017, 09:50 AM
RE: X axis not working correctly - by edeeec - 01-08-2017, 04:56 PM
RE: X axis not working correctly - by Yuriy - 01-10-2017, 03:27 AM
RE: X axis not working correctly - by edeeec - 01-11-2017, 09:41 AM
RE: X axis not working correctly - by edeeec - 01-28-2017, 04:15 PM
RE: X axis not working correctly - by Yuriy - 01-30-2017, 05:41 PM
RE: X axis not working correctly - by edeeec - 02-05-2017, 03:23 PM
RE: X axis not working correctly - by edeeec - 02-23-2017, 08:37 AM
RE: X axis not working correctly - by Yuriy - 02-24-2017, 03:26 PM
RE: X axis not working correctly - by edeeec - 02-25-2017, 03:08 PM
RE: X axis not working correctly - by Yuriy - 02-25-2017, 04:39 PM
RE: X axis not working correctly - by edeeec - 02-27-2017, 08:43 AM
RE: X axis not working correctly - by Yuriy - 02-27-2017, 03:25 PM
RE: X axis not working correctly - by edeeec - 03-11-2017, 06:58 PM
RE: X axis not working correctly - by edeeec - 03-22-2017, 09:53 PM
RE: X axis not working correctly - by Briney Eye - 03-22-2017, 09:59 PM
RE: X axis not working correctly - by heavyg603 - 03-26-2017, 12:59 AM
RE: X axis not working correctly - by Briney Eye - 03-26-2017, 10:58 PM
RE: X axis not working correctly - by keesk - 10-10-2017, 01:04 PM
RE: X axis not working correctly - by Philcobt - 02-26-2018, 11:26 PM
RE: X axis not working correctly - by Yuriy - 02-27-2018, 02:30 AM
RE: X axis not working correctly - by Philcobt - 02-27-2018, 04:05 PM
RE: X axis not working correctly - by qtron - 06-28-2018, 03:44 PM
RE: X axis not working correctly - by qtron - 10-29-2020, 12:27 PM
RE: X axis not working correctly - by Yuriy - 10-29-2020, 05:00 PM
RE: X axis not working correctly - by qtron - 10-30-2020, 01:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)