02-09-2021, 04:08 PM
First post here
I have an Acu-rite G2 CNC controller, and I am trying to interface an Easson GS-11. Mainly for cost savings. The SENC is over $1100, the Easson is $230. Since I'm green I don't fully understand the differences in the scale output. Both do TTY and have 1 micron resolution, but the Senc has A-, B-, and R-. The Easson does not. I'm just trying to get my machines up and running, and save my company some cash. I'm new to DRO's, but not to Machining or electronics. Any help is greatly appreciated.
This is for the Easson
I will attach a diagram for the SENC as soon as I figure out how to.
I have an Acu-rite G2 CNC controller, and I am trying to interface an Easson GS-11. Mainly for cost savings. The SENC is over $1100, the Easson is $230. Since I'm green I don't fully understand the differences in the scale output. Both do TTY and have 1 micron resolution, but the Senc has A-, B-, and R-. The Easson does not. I'm just trying to get my machines up and running, and save my company some cash. I'm new to DRO's, but not to Machining or electronics. Any help is greatly appreciated.
This is for the Easson
I will attach a diagram for the SENC as soon as I figure out how to.