01-30-2021, 07:55 PM
I am completely new to using a DRO. See the video.
https://photos.app.goo.gl/sPa5k7AzjAEQQ7pw6
I am assuming I am doing something wrong but I am not sure.
The only way I can get this to work right is after I indicate on the edge I move over .1 then zero out again. The edge finger is set to a diameter of .2. The mill is .5
I would have thought that TouchDRO would have done the math for this.
https://photos.app.goo.gl/sPa5k7AzjAEQQ7pw6
I am assuming I am doing something wrong but I am not sure.
The only way I can get this to work right is after I indicate on the edge I move over .1 then zero out again. The edge finger is set to a diameter of .2. The mill is .5
I would have thought that TouchDRO would have done the math for this.