Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What am I doing wrong?
I am completely new to using a DRO.  See the video.

I am assuming I am doing something wrong but I am not sure.

The only way I can get this to work right is after I indicate on the edge I move over .1 then zero out again.  The edge finger is set to a diameter of .2. The mill is .5

I would have thought that TouchDRO would have  done the math for this.
I think you need to set the tool offset in the settings and select the tool, then switch tool to what you are using with it's offset stored under tools as well. If I understand what you are saying correctly.

Each tool can have it's own offsets saved.

Forum Jump:

Users browsing this thread: 1 Guest(s)