01-08-2021, 07:27 AM
Ron,
You need to indicate the center of the flange. With the spindle over the center, set the radius and starting hole angle (if it's not at 12 o'clock).
You can easily check the result by looking at the workspace preview.
Dave M. has a good video on this here: https://www.youtube.com/watch?v=Lsna5BH-...nnel=DaveM
Regards
Yuriy
You need to indicate the center of the flange. With the spindle over the center, set the radius and starting hole angle (if it's not at 12 o'clock).
You can easily check the result by looking at the workspace preview.
Dave M. has a good video on this here: https://www.youtube.com/watch?v=Lsna5BH-...nnel=DaveM
Regards
Yuriy