Tool position help

[RonM]

Hi, total noob here 
I was wondering if someone could help me with drilling 3 holes in a flange.
I have clamped the workpiece down and accessed the hole drilling feature and put in my 
Pcd radius and number of holes. I left the starting angle and finishing angle at 0
I just don't know how to set the starting position of the drill or set the starting position 
Of the workpiece. What am I missing? Any help appreciated

Ron

[Yuriy]

Ron,
You need to indicate the center of the flange. With the spindle over the center, set the radius and starting hole angle (if it's not at 12 o'clock).
You can easily check the result by looking at the workspace preview.

Dave M. has a good video on this here: https://www.youtube.com/watch?v=Lsna5BH-...nnel=DaveM
Regards
Yuriy