10-20-2020, 02:09 PM
Hi All,
I have been using the DRO on my lathe, using 2 glass scales and the Tach connected, and the display on a 10" tablet. Using mm settings.
Very usefull sofar.
However, when using the Settings-Tools function, I get a strange error in the DRO App:
I can not imagine no one else has encountered this situation yet?
Thanks for your help,
Frans
I have been using the DRO on my lathe, using 2 glass scales and the Tach connected, and the display on a 10" tablet. Using mm settings.
Very usefull sofar.
However, when using the Settings-Tools function, I get a strange error in the DRO App:
- I added a tool, give it a name, and a radius offset for the X axis.
I am using the Diameter options on the main screen.
- I set the X-axis to 'Zero' using the short tab on the display.
All ok, the reading of the X changes to twice the radius setting of the tool.
- When I want to change the tool-offset, and use the "Edit tool" function, I can not change the offset only. The name of the tool is blank, and I need to specify the name again.
That is strange.
- Also when I save the edited tool, the tool offset for X in the tool-list, is multiplied by 1000 or 10000 factor..
And when I set the X display to zero, it uses this multiplied value as well.
I can not imagine no one else has encountered this situation yet?
Thanks for your help,
Frans