09-14-2020, 10:47 AM
Hi all,
Trying to get an MSP430 working with Glass scales, but cannot figure out the wiring of the 2 resistor voltage divider.
I am using Ditron scales with a Dsub 9 connector, The pinouts is the same as what is posted on the site.
I am hoping for an actual photo as it is hard me to to understand the diagrams on the site. Just really need a photo of how 1 axis is setup as I will be able to figure out how to wire the additional axis's
This is the page I have been looking at. https://www.yuriystoys.com/2014/01/conne...es-to.html
Also I assume I don't need any additional power supplies, just the usb phone charger which will power the MSP430 and the glass scales?
I previously built the igaging diy msp430 by following the detailed photos but I can no longer use it as I ended up with an incompatible Chinese scale.
Thank you
Trying to get an MSP430 working with Glass scales, but cannot figure out the wiring of the 2 resistor voltage divider.
I am using Ditron scales with a Dsub 9 connector, The pinouts is the same as what is posted on the site.
I am hoping for an actual photo as it is hard me to to understand the diagrams on the site. Just really need a photo of how 1 axis is setup as I will be able to figure out how to wire the additional axis's
This is the page I have been looking at. https://www.yuriystoys.com/2014/01/conne...es-to.html
Also I assume I don't need any additional power supplies, just the usb phone charger which will power the MSP430 and the glass scales?
I previously built the igaging diy msp430 by following the detailed photos but I can no longer use it as I ended up with an incompatible Chinese scale.
Thank you