Posts: 323
Threads: 2
Joined: May 2016
Reputation:
10
James,
The foil should be grounded on one end. IF you have an Ohm meter, check the continuity between the foil and the scale's frame. IF you get an "open", ground it on the side where you connect it to the DRO.
Regards
Yuriy
Posts: 11
Threads: 5
Joined: Feb 2020
Reputation:
0
hello Yuriy i checked and it is not grounded on the scale side. appears to be a floating shield? im gonna check the cut off end by cutting the connector open to check wire pin out. thanks
Posts: 11
Threads: 5
Joined: Feb 2020
Reputation:
0
hello im not getting a ground reading on either side . the pin out is; 1-red,2-white,3-grn,4-brn.5-blk..4 and 5 should be ground ?
Posts: 11
Threads: 5
Joined: Feb 2020
Reputation:
0
hello got a fresh start at it again today..ran test from foil to black pin-5 and got a reading.it is grounded at dro. and not at scale.thanks