Tach Manual Input

[jpigg55]

I recently tried inputting the RPM in the Tach feature in order to use the Chip Load feature, but it wouldn't take.
I currently don't have a tach with just step pulleys for speed control.
I enabled the Tach on the Settings and input the RPM, but it just kept defaulting back to zero.

I'll be working in my shop again today and will give it another try, but thought I'd see if anyone had any recommendations.

[Mark Smith]

I have the same problem. Did you figure it out?

[jpigg55]

No I haven't, but I haven't been in the shop for awhile either to see if anything had been updated to fix the issue.