10-05-2019, 06:37 PM
How much if any difference would be in,
1 . The circuitry and its resilience to stay signals, partially this needs the board to well designed but also how you wire it in and how close the wires get to motors etc.
2. The 1 micron scales need to output a A B and =A and -B which can then be compared and used to recognise stray signals.
3. The board needs to receive and use these -A and -B .
This can be done with Yuri's boards.
The only feature I have seen elsewhere is variable calibration, ie where you can divide the scale range and calibrate each zone differently from the other zones. But if you are using new scales this should not be needed.
1 . The circuitry and its resilience to stay signals, partially this needs the board to well designed but also how you wire it in and how close the wires get to motors etc.
2. The 1 micron scales need to output a A B and =A and -B which can then be compared and used to recognise stray signals.
3. The board needs to receive and use these -A and -B .
This can be done with Yuri's boards.
The only feature I have seen elsewhere is variable calibration, ie where you can divide the scale range and calibrate each zone differently from the other zones. But if you are using new scales this should not be needed.