Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Arduino Uno no data from scales.
#1
Ok so I'm new to this. Built the Uno controller. But when I go in to the serial monitor all I'm getting is x0 y0 z0 w0. So I'm not getting signal from the scales. I have power 3.3v ,clock is at 1.5v and ground connected to a micro usb breakout board. Wiring is correct. The scales look identical to the igaging scales. I bought them from banggood. Anybody have any idea what it could be ?? The one thing I do notice is , when I place a muti-meter on pins 3,4 and 5 of the shield I have continuity acoss all the pins. Also I'm just clearing the screen on the Arduino IDE and pasteing the code directly on the screen and uploading it to the Uno. Is that correct ??
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)