Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DRO runs away when I turn on motor
#2
A couple of things to try:
1. Power the scale interface from a different plug, e.g. across the room.
2. Make sure there is no oil etc. on the Z scale.
3. Electrically isolate the Z scale from the frame of the lathe

I have a KC1022 with KBCC-125R. The only problem so far was cutting oil on the Z axis scale giving problems. I sealed the cover better to avoid that in future.
Reply


Messages In This Thread
DRO runs away when I turn on motor - by Zoltan - 02-14-2019, 11:30 AM
RE: DRO runs away when I turn on motor - by gerritv - 02-14-2019, 01:47 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)