01-15-2019, 02:53 AM
I have the "No Solder Kit" and have just finished the install.
When I built the enclosure I tested it with just moving a scale by hand and everything was fine.
Now that I have everything connected I get no response from the X axis input. The scale is fine. it works when I connect it to an other input. Also I swapped the header connectors to see if the problem was in there.
Every part works in every combination as long as it is not connected to the X axis input.
Is there a setting that I am not checking or do I have a problem? I am scratching my head.
Jay
When I built the enclosure I tested it with just moving a scale by hand and everything was fine.
Now that I have everything connected I get no response from the X axis input. The scale is fine. it works when I connect it to an other input. Also I swapped the header connectors to see if the problem was in there.
Every part works in every combination as long as it is not connected to the X axis input.
Is there a setting that I am not checking or do I have a problem? I am scratching my head.
Jay