Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dead X axis input
#1
I have the "No Solder Kit" and have just finished the install.

When I built the enclosure I tested it with just moving a scale by hand and everything was fine.

Now that I have everything connected I get no response from the X axis input.  The scale is fine. it works when I connect it to an other input.  Also I swapped the header connectors to see if the problem was in there.

Every part works in every combination as long as it is not connected to the X axis input.

Is there a setting that I am not checking or do I have a problem?  I am scratching my head.

Jay
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)