Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lathe-specific version?
#1
Most of the examples I see are milling functions. Is there a version of touchDRO just for the lath-functions?
Reply
#2
It's just a matter of how you set it up. I have a setup called "Lathe" and one called "Mill." Look more closely at how the axes are configured.
Reply
#3
Thanks - I don’t have the set up yet- just looking it over. I have a mill with commercial DRO - was wondering if when touchDRO is set up for LATHE are there any specific functions for lathe work. I guess the work on a mill can be more complicated, and lathe-work can be a bit more simple. When you set up for LATHE mode, do the mill functions become hidden?
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)