Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Touch probe?
#5
Hi Midnite,

The LED on my mixed signal board (set for quadrature) is best mounted behind the mill facing the wall. So having the touch LED repeated on the display would be nice.

Also the touch probe has many possible extra functions that could then be implemented such as self calibration, edge and mid point detection.

My Bluetooth disconnects 1-2 times a day. Since I'm bench testing it in the house, I am sure it isn't related to any motor interference in the workshop.
Reply


Messages In This Thread
Touch probe? - by MidniteMachinist - 06-01-2018, 03:51 AM
RE: Touch probe? - by MidniteMachinist - 06-04-2018, 08:00 AM
RE: Touch probe? - by bobdring - 06-05-2018, 07:05 PM
RE: Touch probe? - by MidniteMachinist - 06-07-2018, 02:49 AM
RE: Touch probe? - by bobdring - 06-07-2018, 05:39 AM
RE: Touch probe? - by MidniteMachinist - 06-07-2018, 05:54 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)