Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Toch pad or similar
#1
Hi guy's.
Do any of you use a touch off pad or similar?. I have a lot of tool changes of different lengths during a session
and I would like to learn the best way to deal with it.
Thanks
John
Reply
#2
(05-05-2018, 11:02 PM)Johno1958 Wrote: Hi guy's.
Do any of you use a touch off pad or similar?. I have a lot of tool changes of different lengths during a session
and I would like to learn the best way to deal with it.
Thanks
John

John,
Current version doesn't support probe input. The upcoming version will have full support for touch off pad. 
I'd be curious if anyone uses the probe light on the board in some way to deal with tool changes.

Thank you
Yuriy
Reply
#3
(05-06-2018, 03:19 AM)ejv5f Wrote:
(05-05-2018, 11:02 PM)Johno1958 Wrote: Hi guy's.
Do any of you use a touch off pad or similar?. I have a lot of tool changes of different lengths during a session
and I would like to learn the best way to deal with it.
Thanks
John

John,
Current version doesn't support probe input. The upcoming version will have full support for touch off pad. 
I'd be curious if anyone uses the probe light on the board in some way to deal with tool changes.

Thank you
Yuriy

Thanks Yuriy.
Sounds like the next version is going to be outstanding.
Cheers
John
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)