04-16-2018, 05:14 PM
I am finally calibrating My TouchDRO on my Clausing 8520 vertical mill.
I have X Y and Z calibrated but having problems with W.
I am using the 1" side of my 123 bar.
I zero out and go down to the table and get 306.56 (note no ") for 1" of travel.
If I zero on the table and go up to the test block I get 355.92 (again no ") for 1" of travel.
Help!!
I have no idea what is going on.
It keeps jumping to incr even when I select abs for all of the scales.
Ralph
I have X Y and Z calibrated but having problems with W.
I am using the 1" side of my 123 bar.
I zero out and go down to the table and get 306.56 (note no ") for 1" of travel.
If I zero on the table and go up to the test block I get 355.92 (again no ") for 1" of travel.
Help!!
I have no idea what is going on.
It keeps jumping to incr even when I select abs for all of the scales.
Ralph