08-22-2016, 02:05 PM
(This post was last modified: 08-22-2016, 02:20 PM by chucketn.
Edit Reason: add info
)
I have successfully modified sketch to read a cheap cheap HF caliper and send the data to TouchDRO via the Bluetooth. I have actually seen it work once! I am going nutz trying to get everything to work reliably.
Using Touchdro v 2.5.10, Arduio Uno, Bluetooth HC-06.
I can use Tera-Term (on my PC) terminal program to see the data transmitted from the Bluetooth. I currently have only one caliper hooked up so I'm sending '0' to TouchDRO for Y and Z, and have y and z disabled in TouchDRO. Bluetooth on the Android says it's pared with HC-06.
when I open TouchDRO and try to connect, connects and drops the connection almost immediately.I never get as far as setting the X CPI. I swear it did connect once and the X axis readout agreed with the caliper. TouchDro changed from mm to in mode and even zeroed the readout.
Help!
It's been a struggle but I'm not giving up...
Chuck
Using Touchdro v 2.5.10, Arduio Uno, Bluetooth HC-06.
I can use Tera-Term (on my PC) terminal program to see the data transmitted from the Bluetooth. I currently have only one caliper hooked up so I'm sending '0' to TouchDRO for Y and Z, and have y and z disabled in TouchDRO. Bluetooth on the Android says it's pared with HC-06.
when I open TouchDRO and try to connect, connects and drops the connection almost immediately.I never get as far as setting the X CPI. I swear it did connect once and the X axis readout agreed with the caliper. TouchDro changed from mm to in mode and even zeroed the readout.
Help!
It's been a struggle but I'm not giving up...
Chuck