08-21-2017, 06:21 PM
Hi y'all. Been snooping here and reading up for some time now in prep to outfit my Grizzly G0768 lathe with DRO.
First, thank you Yuri for your work on this. I'm a huge proponent of openSource and DIY. I don't want to spend more on a DRO system than my lathe is worth
So I'm going with iGaging scales. I'm debating between the aluminum and Stainless. I thought I saw a post where Yuri said once mounted, is no appreciable difference in accuracy? I don't mind spending the extra for stainless if it buys me stability, noise reduction, or any other positive.
I'm going to get the the board with Micro B's and either the aluminum or stainless from Amazon depending on feedback here.
Tablet -- going to go to Costco and see what's available cheap and big
thanks guys and HI
Jim
Dallas, Tx
First, thank you Yuri for your work on this. I'm a huge proponent of openSource and DIY. I don't want to spend more on a DRO system than my lathe is worth

So I'm going with iGaging scales. I'm debating between the aluminum and Stainless. I thought I saw a post where Yuri said once mounted, is no appreciable difference in accuracy? I don't mind spending the extra for stainless if it buys me stability, noise reduction, or any other positive.
I'm going to get the the board with Micro B's and either the aluminum or stainless from Amazon depending on feedback here.
Tablet -- going to go to Costco and see what's available cheap and big

thanks guys and HI

Jim
Dallas, Tx