Posts: 18
Threads: 8
Joined: Jul 2016
Reputation:
2
Thanks for watching. My little YouTube channel has a lot of growing yet to do, but it's coming along bit by bit. Your software and Al's module are sure to be featured in upcoming videos.
Al contributed 2 of his modules to the Bar Z Summer Bash in CA a couple of weeks back. One of them went unclaimed by the winner so Stan (Bash organizer) sent it to me (after a bit of nagging and begging). It literally took less than a minute to put it in place and start using it. I had a few minutes yesterday in the shop and installed it on my lathe. Don't even have a mount for the tablet yet - that will probably be Saturday's project.
I have another module ordered from Al that will go on my mill. I am so looking forward to having a DRO with a large enough display for an old man's eyes.
Thanks so much for this project!