Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"Chip load function not available" message
#1
Is there a way to disable the "Chip load function not available." popup message?  Whenever I go into one of the axis-details screens, or change the position in  one of the axis-detail screens, this message pops up.  Right now I don't intend to use the tach or tool definitions so having this message reoccur so often is a bit bothersome.

Thanks

Tim
Reply
#2
(04-14-2017, 02:34 AM)tosborn Wrote: Is there a way to disable the "Chip load function not available." popup message?  Whenever I go into one of the axis-details screens, or change the position in  one of the axis-detail screens, this message pops up.  Right now I don't intend to use the tach or tool definitions so having this message reoccur so often is a bit bothersome.

Thanks

Tim

Tim,
Not in the version you have. I got rid of it in the new version, though.
Regards
Yuriy
Reply
#3
(04-14-2017, 03:13 AM)Yuriy Wrote: Tim,
Not in the version you have. I got rid of it in the new version, though.
Regards
Yuriy

That sounds good.  Do you have an estimate when the new version will be available? 

I'm loving TouchDRO along with your Igaging Adapater.  You've created an amazing and cost effective tool for accurate machining.

Thanks.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)