Software Documentation

[Georges GUAL]

Dick,
It's already excellent to have done this research work and I think it helps a lot of people.
I thank you for all this .... good luck
Georges

Dick,
C'est déjà excellent d'avoir fait ce travail de recherche et je pense que cela ve aider pas mal de monde.
Je te remercie por tout cela.... bonne continuation
Georges

[sonex569@frontier.com]

Thanks Georges,

Weather It helps or not I have learned a lot by digging into it. Thanks for the vote of confidence.

Regards

Dick

[sonex569@frontier.com]

Added to Manual;

New Revision page
New Table of contents pages
Section 10 Lathe

Regards

Dick

See attached

[llamatrails]

Great job, thanks a lot.  Well done.

Can't find :
Add -----4.4 Set RPM Function___________ Page 7

Can you upload it or just upload a current, complete pdf ?

TIA,
Rick

[sonex569@frontier.com]

Hope this helps.

[llamatrails]

Thanks again !!!

[patpommi]

Hello Dick,

I'm new at TouchDRO and also on miling.
Your documentation helps me much to understand the app.

I think you make a great Job. And thanks for sharing your explorance in this Forum!

Greatings,
Ralf 

Ps.: Sorry for my bad english...

[Georges GUAL]

Merci...

Georges

[silopolis]

Thank you very much for sharing this work with the us

Best regards
Jérémie

[S1loki]

solid work! Thanks for putting it all together.