Thread Rating:
  • 1 Vote(s) - 5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Software Documentation
#21
Dick,
It's already excellent to have done this research work and I think it helps a lot of people.
I thank you for all this .... good luck
Georges

Dick,
C'est déjà excellent d'avoir fait ce travail de recherche et je pense que cela ve aider pas mal de monde.
Je te remercie por tout cela.... bonne continuation
Georges
Reply
#22
Thanks Georges,

Weather It helps or not I have learned a lot by digging into it. Thanks for the vote of confidence.

Regards

Dick
Reply
#23
Added to Manual;

New Revision page
New Table of contents pages
Section 10 Lathe

Regards

Dick

See attached


Attached Files
.pdf   Page II Revision.pdf (Size: 133.31 KB / Downloads: 122)
.pdf   Page III-IV Table of Contents.pdf (Size: 63.3 KB / Downloads: 103)
.pdf   Section 10 Lathe.pdf (Size: 495.2 KB / Downloads: 154)
Reply
#24
Great job, thanks a lot.  Well done.

Can't find :
Add -----4.4 Set RPM Function___________ Page 7

Can you upload it or just upload a current, complete pdf ?

TIA,
Rick
Reply
#25
Hope this helps.


Attached Files
.pdf   User Manual.pdf (Size: 1.91 MB / Downloads: 322)
Reply
#26
Thanks again !!!
Reply
#27
Hello Dick,

I'm new at TouchDRO and also on miling.
Your documentation helps me much to understand the app.

I think you make a great Job. And thanks for sharing your explorance in this Forum!

Greatings,
Ralf 

Ps.: Sorry for my bad english...
Reply
#28
Merci...

Georges
Reply
#29
Thank you very much for sharing this work with the us

Best regards
Jérémie
Reply
#30
solid work! Thanks for putting it all together.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)