Forum › General Discussion › General Help and Support v
The probe does not work with Arduino

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Threaded Mode
The probe does not work with Arduino
casperino67 Offline
Newbie
*
Posts: 3
Threads: 1
Joined: Mar 2017
Reputation: 0
#1
03-08-2017, 07:19 PM
Hello, I realized the DRO and works well with arduino nano, everything works except the probe! I downloaded version 5.11. Can you help me with some instruction? Thanks so much.
Find
Reply
casperino67 Offline
Newbie
*
Posts: 3
Threads: 1
Joined: Mar 2017
Reputation: 0
#2
03-10-2017, 09:48 PM
no one helps me?
Find
Reply
Briney Eye Offline
Member
***
Posts: 88
Threads: 4
Joined: Jan 2017
Reputation: 5
#3
03-11-2017, 06:09 AM
I believe that you need to connect your probe between the probe input and VCC, but I'm not 100% sure since I'm only using the lathe functions. When you power up it looks at whether the switch is open or closed and chooses the other state as a "touch".
Find
Reply
casperino67 Offline
Newbie
*
Posts: 3
Threads: 1
Joined: Mar 2017
Reputation: 0
#4
03-11-2017, 06:36 PM
Hi, thank you! However, I have connected pin probe to zero level, I then rebooted Arduino and then I brought the probe pin to + Vcc and I not work! I also tried the contrary but the same does not work ! I think there is a bug in the sketch Arduino ..... We hope that some good soul like you to help me !!
Find
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)