Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Shars scales with Touch DRO
#10
I looked over the wiring and read connecting igaging
scales to touchdro controller page 3 times. 
I checked test points to usb .
the board i was sent has 8 holes per axis to wire
do you use the 4 to the outside?
I checked the vcc and ground with a multimeter but
the data + clock i have no way to check.
the board amber light dose not blink rapidly to detect protocols
it jest blinks?
some times the red led lights.
thanks for the help!
Reply


Messages In This Thread
Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 01:36 PM
RE: Shars scales with Touch DRO - by Yuriy - 02-12-2017, 05:20 PM
RE: Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 07:17 PM
RE: Shars scales with Touch DRO - by Yuriy - 02-12-2017, 09:17 PM
RE: Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 09:21 PM
RE: Shars scales with Touch DRO - by Briney Eye - 02-26-2017, 05:53 PM
RE: Shars scales with Touch DRO - by Briney Eye - 02-23-2017, 06:43 AM
RE: Shars scales with Touch DRO - by geiges - 04-21-2017, 10:31 PM
RE: Shars scales with Touch DRO - by Briney Eye - 04-22-2017, 02:38 AM
RE: Shars scales with Touch DRO - by geiges - 04-22-2017, 03:50 AM
RE: Shars scales with Touch DRO - by Briney Eye - 04-22-2017, 03:36 PM
RE: Shars scales with Touch DRO - by Yuriy - 04-22-2017, 04:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)