Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Shars scales with Touch DRO
#6
The 6" and 24" Shars aluminum scales that I just bought (303-9270 and 303-9272) seem to work fine. Cost $75 with shipping.

Construction is on the flimsy side, but they work a treat on the bench. O'scope shows clean waveforms on the Mixed Scale board. They use the 21-bit format, 2540 CPI. Set the jumpers to 3.3V, pull-down resistors, and clock jumpers installed.

I just have to mount them now.
Reply


Messages In This Thread
Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 01:36 PM
RE: Shars scales with Touch DRO - by Yuriy - 02-12-2017, 05:20 PM
RE: Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 07:17 PM
RE: Shars scales with Touch DRO - by Yuriy - 02-12-2017, 09:17 PM
RE: Shars scales with Touch DRO - by Shawn_Howell - 02-12-2017, 09:21 PM
RE: Shars scales with Touch DRO - by Briney Eye - 02-26-2017, 05:53 PM
RE: Shars scales with Touch DRO - by Briney Eye - 02-23-2017, 06:43 AM
RE: Shars scales with Touch DRO - by geiges - 04-21-2017, 10:31 PM
RE: Shars scales with Touch DRO - by Briney Eye - 04-22-2017, 02:38 AM
RE: Shars scales with Touch DRO - by geiges - 04-22-2017, 03:50 AM
RE: Shars scales with Touch DRO - by Briney Eye - 04-22-2017, 03:36 PM
RE: Shars scales with Touch DRO - by Yuriy - 04-22-2017, 04:33 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)