Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cheap Magnetic Heads
I want to try and use the read heads from this DRO package...

There are obviously no pinout diagrams or ability to contact the manufacturer.  Anyone have any experience with these sensors or can point me in the right direction to figure out the pins?  The sensors are hard wired to the board with no markings.  There is a shield wire and then 5 smaller gauge wires of various colors.

Thanks in advance!

Forum Jump:

Users browsing this thread: 1 Guest(s)