Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MSP430 probe
Hi, many moons ago I built a DIY kit using the MSP430 proto board, and it been fantastic.

Can anyone tell me if the probe input was ever implemented? I recently bought and added a 3d probe, connected it to pin 1.3 ( as shown in the pinouts ) but it doesn't seem to do anything.

It's enabled in settings, and set to switched 0, as verified using a multimeter.

Any help would be appreciated.


Forum Jump:

Users browsing this thread: 1 Guest(s)