Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Inside/outside probing
Would it be possible to be able to set inside/outside measurements for each probe point?

I was machining a step feature, and needed to drill a hole in the center of the step. I tried to pick up the front of the step (outside measurement), then the back of the step (inside measurement)... But when I tapped the inside/outside button, it switched all the coordinates to "outside".

This has the effect of placing the DRO center exactly one probe-tip-diameter forward (towards the front of the part) of the ACTUAL center.
YouTube: FnA-Wright Engineering

Forum Jump:

Users browsing this thread: 1 Guest(s)