Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Touch probe for axis calibration?
#1
This would be super useful. Being able to use the touch probe would make axis calibration even easier, and likely more accurate.

Especially when calibration micron or sub-micron scales. Trying to land on zero on a tenths indicator can be super fussy, and if you overshoot, you've got to start again. The touch probe will trip at the same point every time, which means overshooting by a few tenths with the handwheel won't matter.
YouTube: FnA-Wright Engineering
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)