07-25-2022, 08:28 AM
Hello,
I love the TouchDRO solution, but i have a little problem.
When i turn on my TouchDRO board, and connect it via blue tooth to my tablet, only one of the x y z inputs respond from the shahe scales, the other two is not responding to the shahe scale input.
After a while where i have switch scale input, ant turned on and off the TouchDRO board, all the inputs get active, but it all is a bit random.
I have tried a few diferent usb power supplies, now i run the TouchDRO from at battery usb power bank, since i suspected powersupply noise was the problem, but i still have this startup problem.
Anyone have the same problem, and maby a solution?
Regards
Martin O
Denmark
I love the TouchDRO solution, but i have a little problem.
When i turn on my TouchDRO board, and connect it via blue tooth to my tablet, only one of the x y z inputs respond from the shahe scales, the other two is not responding to the shahe scale input.
After a while where i have switch scale input, ant turned on and off the TouchDRO board, all the inputs get active, but it all is a bit random.
I have tried a few diferent usb power supplies, now i run the TouchDRO from at battery usb power bank, since i suspected powersupply noise was the problem, but i still have this startup problem.
Anyone have the same problem, and maby a solution?
Regards
Martin O
Denmark