|
Y axis stopped working
|
11-11-2021, 11:00 PM
I have been working with my repaired touch dro with no problem since it was repaired a while ago. Tonight the y axis stopped working. I swapped the x and y and the igage for the y axis works fine in the x slot. What should be my next step to fix this?
11-12-2021, 01:09 AM
(11-11-2021, 11:00 PM)drinkr Wrote: I have been working with my repaired touch dro with no problem since it was repaired a while ago. Tonight the y axis stopped working. I swapped the x and y and the igage for the y axis works fine in the x slot. What should be my next step to fix this? Which version of the board do you have?
11-12-2021, 02:18 PM
I’m not sure if this is the version but the board has 2.4 written in pen on it. Also when I opened it I saw the y micro connector has broken free. I had the wires and box mounted permanently so I didn’t expect that.
11-12-2021, 06:51 PM
(11-12-2021, 02:18 PM)drinkr Wrote: I’m not sure if this is the version but the board has 2.4 written in pen on it. Also when I opened it I saw the y micro connector has broken free. I had the wires and box mounted permanently so I didn’t expect that. That's the "old" MSP430 based board. I had a batch of those with "cold" solder joints and a few made it into the wild before I caught the problem. Yours is likely #8 of that batch. Please email me (yuriy at touchdro dot com). |
|
« Next Oldest | Next Newest »
|
