I have these glass scales on my Lathe saddle, rock steady until moving the saddle with the handwheel and the driven gear hits the 2 teeth missing on the spur gear creates a thud and the display jumps, does the same in both directions. With the saddle in machine feed there is no thud as the missing teeth are not in the machine feed drive and no display jumps.
Readout flickers with motor running (glass scales)
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Readout flickers with motor running (glass scales) - by MidniteMachinist - 07-26-2021, 02:44 PM
RE: Readout flickers with motor running (glass scales) - by Yuriy - 07-27-2021, 12:24 AM
RE: Readout flickers with motor running (glass scales) - by MidniteMachinist - 07-27-2021, 01:50 AM
RE: Readout flickers with motor running (glass scales) - by MidniteMachinist - 07-27-2021, 12:52 PM
RE: Readout flickers with motor running (glass scales) - by jpigg55 - 08-02-2021, 12:56 PM
RE: Readout flickers with motor running (glass scales) - by Yuriy - 08-02-2021, 10:09 PM
RE: Readout flickers with motor running (glass scales) - by kommando - 08-05-2021, 05:32 PM
RE: Readout flickers with motor running (glass scales) - by MidniteMachinist - 08-06-2021, 08:40 PM
RE: Readout flickers with motor running (glass scales) - by MidniteMachinist - 08-19-2021, 11:42 AM
RE: Readout flickers with motor running (glass scales) - by JackFarrellHSul - 10-18-2021, 01:24 PM
|
Users browsing this thread: 1 Guest(s)