08-02-2021, 12:56 PM
Try replacing the vibration dampening motor mounts or adding them if it doesn't have any.
I had a similar issue on my old Clausing mill some years back and replacing them did the trick.
One place to source them is McMaster-Carr: https://www.mcmaster.com/
It's difficult to tell from the video, but it seems I detect a small amount of vibration that can cause this. The mounts are inexpensive and would be a good place to start your troubleshooting.
I had a similar issue on my old Clausing mill some years back and replacing them did the trick.
One place to source them is McMaster-Carr: https://www.mcmaster.com/
It's difficult to tell from the video, but it seems I detect a small amount of vibration that can cause this. The mounts are inexpensive and would be a good place to start your troubleshooting.