06-12-2021, 10:19 PM
Hi Redpiperbob,
If I read your post correctly, I think using pin 1.7 is at least part of your problem.
The more recent firmware does not use a common clock and should be wired to this later configuration:
https://www.yuriystoys.com/2014/01/dro-i...sp430.html
As well as using individual clock pins per scale, you should note the W axis data line has moved.
Also worth noting, that if you're looking for it, the clock signal will not be present on the clock lines unless there was a scale connected when the Launch Pad was reset/powered on, (part of the auto scale detect I suspect).
Hope this helps.
Norman
If I read your post correctly, I think using pin 1.7 is at least part of your problem.
The more recent firmware does not use a common clock and should be wired to this later configuration:
https://www.yuriystoys.com/2014/01/dro-i...sp430.html
As well as using individual clock pins per scale, you should note the W axis data line has moved.
Also worth noting, that if you're looking for it, the clock signal will not be present on the clock lines unless there was a scale connected when the Launch Pad was reset/powered on, (part of the auto scale detect I suspect).
Hope this helps.
Norman