Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
DRO - Dropping Values (inaccurate reading of scales)
#3
Yuriy,

Thank you for the reply! I will try and swap the scales and hopefully isolate the issue to the scales. I'm not excited about getting new scales if that is the case. If it is do you have a recommendation for scales that will work with the board that I have?

I don't know how to reprogram the board and fear I will make it worse. I've read instructions that include downloading software from TI and then using the latest firmware file (.txt) but am unsure about how to connect the board to the computer. I didn't know if there was an intermediate component that should be used. If you are able to walk me through it I am willing to give it a try.

Thanks again!!!

_Mike
Reply


Messages In This Thread
RE: DRO - Dropping Values (inaccurate reading of scales) - by Mtracz - 06-02-2021, 01:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)