Thankyou for the reply Yuriy .. did post #22 get answered? A bit disconcerting.
My f/w ver 1.0, board is Rev 1.2
Other msp430 already swapped out, tested. Same issue.
Assembled & tested by a professional tech. Double checked.
X axis, Z axis also exhibits same symptoms but not as bad as Y axis, which is a consistent fault.
Page 2 of this thread others have binned the project due to being left w no answers..
I havent given up on U!!
(Red LED's are across the vcc's to all scales to constrain vcc's to 1.60 V Max. Didnt help tho.
Where do I find the board wiring schematic?
- Just a good screenshot will do
My f/w ver 1.0, board is Rev 1.2
Other msp430 already swapped out, tested. Same issue.
Assembled & tested by a professional tech. Double checked.
X axis, Z axis also exhibits same symptoms but not as bad as Y axis, which is a consistent fault.
Page 2 of this thread others have binned the project due to being left w no answers..
I havent given up on U!!
(Red LED's are across the vcc's to all scales to constrain vcc's to 1.60 V Max. Didnt help tho.
Where do I find the board wiring schematic?
- Just a good screenshot will do