Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem with on Shahe Scale
#4
Hi Yuriy,

Thank you for your quick reply.
I am using a variable bench testing power supply and I have played with the voltage around 5v. I noted that the two resisters supplied with the kit were 330 ohm and not 220 ohm as specified in the build instructions. I did use the kit resistors. 
The problem is definitely with the one scale (X on my mill)  as it acts up no matter which input that it is plugs into. It seems to be a pulse of about a couple of seconds of random readings. This repeats. This scale works OK with the rectangular Shahe displays that came with it. 
Over the weekend I will take the offending scale off the mill and see if it is OK on the bench. 

Ken

Hi Norman,

I did not recognise the fact that there is a "right" way to put the scale together! I did shorten the scale and took the reader off when I chopped off a few inches. Thank you and I will try the other way over the weekend when I get back into my shed. 
I really appreciate all the help.

Ken
Reply


Messages In This Thread
Problem with on Shahe Scale - by kenhsilver - 05-04-2021, 04:50 PM
RE: Problem with on Shahe Scale - by NormanP - 05-04-2021, 10:22 PM
RE: Problem with on Shahe Scale - by Yuriy - 05-05-2021, 04:26 AM
RE: Problem with on Shahe Scale - by kenhsilver - 05-05-2021, 09:04 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)