Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help with accuracy
#3
I did, I used your method on youtube with 1-2-3 blocks. It took me a little while to get the CPI right to get it to show 3". After that is when I get issues. I could have done that wrong I basically went in ascending order for the CPI till it read 3". Could the scales be causing this if they are not mounted perfectly parallel with the axis?
Reply


Messages In This Thread
Help with accuracy - by Mheaton92 - 04-03-2021, 10:34 PM
RE: Help with accuracy - by Yuriy - 04-03-2021, 10:39 PM
RE: Help with accuracy - by Mheaton92 - 04-04-2021, 12:20 AM
RE: Help with accuracy - by MidniteMachinist - 04-04-2021, 09:25 PM
RE: Help with accuracy - by Mheaton92 - 04-04-2021, 11:21 PM
RE: Help with accuracy - by MidniteMachinist - 04-06-2021, 01:12 PM
RE: Help with accuracy - by Yuriy - 04-06-2021, 03:17 PM
RE: Help with accuracy - by Mheaton92 - 04-06-2021, 10:01 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)