The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.3.27 (Linux)
File Line Function
/showthread.php 864 errorHandler->error




Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Touch DRO on an Axminster ZX25 (Rong Fu RF25)
#1
I actually did my mill first - and as it turned out so well, I did my lathe as well. Smile

[Image: Mill3.jpg]

Z-Axis is mounted on plate that sits under the machine name plate, and is attached to the depth stop arm.

[Image: millzaxis.jpg]

Y-Axis is mounted to the mill in such a way that the scale moves, not the head - so it's not dragging the cable when the table moves

[Image: millyaxis.jpg]

And the X-Axis. The readhead sits behind the auto stop for my shop built power feed.

[Image: millxaxis.jpg]

The interface is mounted on the wall to one side of the mill.

[Image: milliface.jpg]

There is a tach sensor on the mill, but it's not very easy to see - it's a similar setup to the lathe where the sensor is in the head casting, but in this case it's pointing up toward the quill fully sheave, and there's 4 rare earth magnets glued to the underside of it.
Reply


Messages In This Thread
Touch DRO on an Axminster ZX25 (Rong Fu RF25) - by GreatOldOne - 06-16-2016, 04:20 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)