Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Optimum MR000 Read Heads
#11
Stefan,
Are you able to get the output lines to specifically stay at or near 0V and 5V when you move the scales? If the output is quadrature, you should be able to move the scale so each of the output lines reads "low" or "high". If you can get readings inbetween (i.e. you move it a bit and it reads 5v, then 3V, then 1V, etc), the output is not quadrature. Otherwise TouchDRO should read them. There is nothing magic about magnetic scales. The adapter doesn't care where the signal is coming from, as long as it's 5V quadrature output. I test the boards by plugging in four Arduino Nano boards that simulate the signal, for example.
Regards
Yuriy
Reply


Messages In This Thread
Optimum MR000 Read Heads - by stefan333 - 03-21-2021, 05:47 PM
RE: Optimum MR000 Read Heads - by Yuriy - 03-21-2021, 07:59 PM
RE: Optimum MR000 Read Heads - by stefan333 - 03-21-2021, 08:18 PM
RE: Optimum MR000 Read Heads - by Yuriy - 03-22-2021, 05:31 AM
RE: Optimum MR000 Read Heads - by stefan333 - 03-22-2021, 06:36 PM
RE: Optimum MR000 Read Heads - by Yuriy - 03-22-2021, 11:00 PM
RE: Optimum MR000 Read Heads - by stefan333 - 03-23-2021, 07:23 PM
RE: Optimum MR000 Read Heads - by Yuriy - 03-24-2021, 05:14 PM
RE: Optimum MR000 Read Heads - by stefan333 - 03-25-2021, 07:18 PM
RE: Optimum MR000 Read Heads - by stefan333 - 03-29-2021, 06:25 PM
RE: Optimum MR000 Read Heads - by Yuriy - 03-29-2021, 07:09 PM
RE: Optimum MR000 Read Heads - by stefan333 - 03-29-2021, 08:53 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)