Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What am I doing wrong?
#2
I think you need to set the tool offset in the settings and select the tool, then switch tool to what you are using with it's offset stored under tools as well. If I understand what you are saying correctly.

Each tool can have it's own offsets saved.
Reply


Messages In This Thread
What am I doing wrong? - by JoeyG1973 - 01-30-2021, 07:55 PM
RE: What am I doing wrong? - by Hard_ware - 02-02-2021, 07:24 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)