Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
What am I doing wrong?
I am completely new to using a DRO.  See the video.

I am assuming I am doing something wrong but I am not sure.

The only way I can get this to work right is after I indicate on the edge I move over .1 then zero out again.  The edge finger is set to a diameter of .2. The mill is .5

I would have thought that TouchDRO would have  done the math for this.

Messages In This Thread
What am I doing wrong? - by JoeyG1973 - 01-30-2021, 07:55 PM
RE: What am I doing wrong? - by Hard_ware - 02-02-2021, 07:24 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)