Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Tool position help
Hi, total noob here  Smile
I was wondering if someone could help me with drilling 3 holes in a flange.
I have clamped the workpiece down and accessed the hole drilling feature and put in my 
Pcd radius and number of holes. I left the starting angle and finishing angle at 0
I just don't know how to set the starting position of the drill or set the starting position 
Of the workpiece. What am I missing? Any help appreciated


Messages In This Thread
Tool position help - by RonM - 01-08-2021, 06:53 AM
RE: Tool position help - by Yuriy - 01-08-2021, 07:27 AM

Forum Jump:

Users browsing this thread: 2 Guest(s)