Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
MSP430 + Glass Scales, need help with voltage divider
#1
Hi all,

Trying to get an MSP430 working with Glass scales, but cannot figure out the wiring of the 2 resistor voltage divider.

I am using Ditron scales with a Dsub 9 connector, The pinouts is the same as what is posted on the site.

I am hoping for an actual photo as it is hard me to to understand the diagrams on the site.  Just really need a photo of how 1 axis is setup as I will be able to figure out how to wire the additional axis's

This is the page I have been looking at.  https://www.yuriystoys.com/2014/01/conne...es-to.html

Also I assume I don't need any additional power supplies, just the usb phone charger which will power the MSP430 and the glass scales?

I previously built the igaging diy msp430 by following the detailed photos but I can no longer use it as I ended up with an incompatible Chinese scale.

Thank you
Reply


Messages In This Thread
MSP430 + Glass Scales, need help with voltage divider - by robgeorge - 09-14-2020, 10:47 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)