Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bolt holes in YZ plane?
#1
I'm probably the only person asking for this, but hey, why not? I had a large piece (14" long - too much for my limited Z) that needed a hole pattern in the end. I have a right-angle spindle attachment, so I laid the part flat on the table and set up to drill holes using my X feed rather than the quill. It would have been nice to put the hole pattern in TouchDRO, but it looks like it will only let you input a pattern in the XY plane. This time I needed the pattern to be in the ZY plane so I had to use ol' pencil and paper.
Reply


Messages In This Thread
Bolt holes in YZ plane? - by lens42 - 11-04-2016, 07:37 AM
RE: Bolt holes in YZ plane? - by llamatrails - 11-10-2016, 12:35 AM
RE: Bolt holes in YZ plane? - by Yuriy - 11-15-2016, 10:23 PM
RE: Bolt holes in YZ plane? - by Eskimo2k - 01-29-2017, 02:52 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)